Professional solutions tailored to your needs with the highest standards of quality.
Before a single piece of drywall comes out, we build a complete picture of what the damage actually is and how far it has traveled. Restotech uses non-invasive diagnostic equipment to read moisture, temperature and air quality behind finished surfaces, so the...
Thermal imaging reads surface temperature differentials across walls, ceilings and floors. Because evaporating moisture cools a surface, water that has migrated inside an assembly shows up as a distinct thermal pattern long before it becomes a visible stain. B...
Moisture mapping converts a water loss into measurable data. We record moisture content readings at fixed, repeatable points across every affected material, plot them against a dry standard established from unaffected material of the same type in the same stru...
Not every dark stain is mold, and not every mold problem is visible. Microbial assessment establishes whether microbial growth is present, what type it is, how much of the structure it affects and what conditions are sustaining it. Restotech performs the field...
Buildings constructed before 1978 frequently contain lead-based paint, and asbestos was used in drywall joint compound, floor tile and mastic, popcorn ceilings, pipe and duct insulation, roofing and stucco well into the 1980s. Disturbing these materials during...
Indoor air quality complaints rarely have a single cause. A property may carry fungal growth in a wall cavity, bacterial contamination from a sewage backup, residual smoke particulate from a fire, and elevated volatile organic compounds from building materials...
A basement that floods repeatedly does not have a drying problem, it has a water management problem. Restotech addresses the hydrostatic pressure, grading, drainage and envelope failures that let water into below-grade space in the first place. Waterproofing t...
Remediation is not finished when the debris leaves the site. It is finished when objective testing confirms that the contaminant is gone, the affected materials meet dry standard, and the area is safe to reoccupy and rebuild. Post-remediation verification is t...
When a loss involves asbestos, lead, mercury, PCBs, refrigerants or other regulated materials, the project stops being a restoration job and becomes a compliance project with multiple licensed trades, notification deadlines and clearance requirements. Restotec...
Rodents, raccoons, opossums, birds and bats in an attic, crawlspace, chimney or wall cavity leave behind a biohazard, not just a nuisance. Accumulated droppings and urine carry pathogens including Histoplasma capsulatum in bird and bat guano and hantavirus in...
Insulation is porous, and once it has been wet, contaminated by sewage, saturated with smoke residue, or fouled by rodent or bat activity, it cannot be cleaned in place and it will not dry to a safe condition. Compressed, settled or displaced insulation also s...
Persistent odor is a symptom with a physical source: smoke residue bonded to surfaces and absorbed into porous materials, microbial growth in a wall cavity, sewage saturation under flooring, animal urine in insulation and framing, spoiled contents, or off-gass...
A roof opened by fire, storm, fallen tree or structural failure exposes the entire building to weather, animals and unauthorized entry, and every hour it stays open multiplies the damage below. Restotech responds around the clock to secure the opening, protect...
Broken windows, forced or burned doors, and openings left by vehicle impact or vandalism leave a property exposed to weather, theft, squatting and liability. Whether the building is a home after a fire, a storefront after a break-in or a vacant property awaiti...
When a roof is damaged but the deck is still largely intact, a properly installed tarp is the fastest way to stop water from entering while permanent repairs are scoped, approved and scheduled. Done correctly it holds through wind and rain for weeks. Done poor...
Not every damaged opening should be boarded. Reinforced tarp and shrink-wrap closures let light into the building, avoid additional fastener penetrations in historic or finished surfaces, and can be installed on openings where structural panels are impractical...
Fire, prolonged water saturation, impact and soil movement can compromise load-bearing capacity in framing, joists, beams and slabs. Once that happens, no restoration work should proceed until the structure is stabilized. Temporary shoring carries the load saf...
A fire-damaged, flooded or partially demolished property is a hazard and an open invitation. Temporary fencing establishes a controlled perimeter that keeps the public, children, animals and unauthorized entrants out, keeps equipment and salvaged contents in,...
Restotech handles water losses end to end: emergency response and source control, extraction, structural drying, antimicrobial treatment, contents care, and reconstruction back to pre-loss condition. Because one company carries the project from the first call...
Water that enters a building from outside, from storm surge, rising groundwater, overwhelmed storm drains or a failed retaining structure, is Category three water. It carries soil, sewage, agricultural and industrial runoff, fuel and pathogens, and it contamin...
Every gallon of standing water removed mechanically is a gallon that does not have to be evaporated, and evaporation is the slow, expensive part of drying. More importantly, materials degrade on a clock. Drywall wicks, hardwood cups, laminate delaminates, and...
Structural drying is a controlled physical process governed by temperature, humidity, airflow and material permeability. Placing equipment by instinct produces long drying times, high bills and buildings that never actually reach dry standard. Restotech calcul...
Flooring and wall assemblies are layered systems, and water almost always ends up between the layers where surface airflow cannot reach it. The default answer is demolition. The better answer, when it is caught in time, is specialty drying that pulls moisture...
Water entering through a roof does not fall straight down. It runs along the underside of the deck, follows rafters and truss chords, saturates insulation, pools on top of ceiling drywall and then travels laterally into wall cavities and lower floors. By the t...
Attic moisture comes from roof leaks, storm intrusion, HVAC condensation, disconnected bath and dryer vents discharging into the space, and inadequate ventilation that lets warm humid air condense on the cold roof deck. Because attics are rarely entered, the p...
A wet crawlspace is a house-wide problem. Air moves upward through the structure by stack effect, carrying moisture, mold spores, musty odor and soil gas into living space, which is why crawlspace conditions show up as indoor air quality complaints on the floo...
Encapsulation converts a vented dirt crawlspace, which continuously feeds ground moisture and humid outside air into the building, into a sealed, dry, conditioned space. For properties that have been dried out more than once, encapsulation is the point at whic...
Attic insulation must be removed rather than topped up when it has been wet, contaminated by rodent or bat activity, saturated with smoke residue, colonized by mold, or compressed and settled below its rated performance. Adding new insulation over compromised...
Rodents, birds, bats, raccoons and insects turn an attic into a contaminated space. Accumulated droppings, urine, nesting material and carcasses carry pathogens, sustain a persistent odor, attract new animals through pheromone trails and continue affecting the...
Sewage backups, trauma and unattended death scenes, hoarding conditions, blood-borne pathogen exposure and animal biohazard are regulated remediation work involving genuine health risk. The contamination is invisible, it aerosolizes, it penetrates porous mater...
A sewage backup is an emergency on a short clock. Contaminated water spreads through the building by gravity and capillary action, saturating porous materials permanently and driving bacteria and pathogens into assemblies within hours. Restotech responds aroun...
Raw sewage is grossly contaminated Category three water carrying bacteria, viruses, protozoa, parasites and endotoxins, including E. coli, Salmonella, Hepatitis A, Giardia and Cryptosporidium. Anything porous it touches is unsalvageable, and the affected area...
Disinfection is effective only after cleaning. Applying an antimicrobial over soil, residue or biofilm inactivates the product and leaves the underlying contamination intact, which is the most common failure in low-cost remediation work. Restotech treats disin...
Mold is remediated by physically removing contaminated material and cleaning what remains, and by eliminating the moisture that made growth possible. Spraying a chemical on colonized drywall does not remediate anything, because dead spores and mycotoxins remai...
Mold frequently leaves permanent discoloration in wood after the organism itself is removed, particularly on attic sheathing, floor joists, subfloor and exposed framing. The staining is not active growth and is not a health hazard, but it fails visual inspecti...
Restotech is an authorized and licensed applicator of the GoldMorr System, a professional mold remediation methodology with defined protocols, proprietary products and a required licensing and training program. Applicator status means our technicians are train...
A fire loss is really four losses stacked together: fire and structural damage, smoke and soot contamination through the entire building, water and chemical damage from suppression, and the contents loss. Restotech carries the project through all of it, from t...
Before any reconstruction can begin, the fire debris has to come out, the structure has to be evaluated and stabilized, and the salvageable has to be separated from the total loss. Fire cleanup is heavy, hazardous work involving unstable framing, sharp debris,...
Smoke follows air pressure and temperature, which means it reaches spaces the fire never touched: closets, drawers, wall cavities, the HVAC system, upper floors and rooms behind closed doors. Soot is acidic and hygroscopic, so it continues to etch metal, disco...
Odor returns because the source was never removed, because odor molecules absorbed into porous materials were never reached, or because the HVAC system redistributed contamination after the treated area was cleaned. Effective deodorization is a sequence, not a...
Thermal fogging works on a simple principle: smoke penetrated the building as a heated, expanded aerosol, so the deodorizing agent has to travel the same way to reach the same places. A thermal fogger heats a solvent-based deodorizer into a dense fog of extrem...
Hydroxyl generators use ultraviolet light to produce hydroxyl radicals, the same oxidizing molecules that break down odors and airborne contaminants in the outdoor atmosphere. Unlike ozone, hydroxyl treatment is safe to run in occupied spaces around people, pe...
Structural damage is measured and scoped by professionals. Contents are usually left to the property owner to remember, list and value from memory, often while displaced and under time pressure. That is where claims are underpaid. Restotech performs a professi...
When a property has to be dried, remediated, gutted or rebuilt, contents left on site are exposed to continued damage, dust, demolition and theft, and they get in the way of the work. Pack-out moves your belongings to a controlled facility where they can be cl...
For most categories of personal property, professional restoration costs a fraction of replacement value, and it returns the specific items that matter rather than generic substitutes. Furniture, textiles, electronics, documents, artwork and heirlooms that loo...
The most common way property owners lose money in a claim is that unsalvageable items are hauled away before they are documented. In the urgency of a fire or sewage loss, ruined furniture, appliances, electronics and personal belongings go straight into a dump...
Carpet is the largest air filter in most buildings. It traps soil, allergens, dander, pollen, dust mite debris and microbial matter, and once that load saturates the fiber it is released back into the air with every footstep. Regular professional cleaning rest...
Hard flooring covers a wide range of materials that tolerate very different treatment. Natural stone is acid-sensitive, polished concrete and terrazzo require specific pad and chemistry combinations, luxury vinyl and sheet goods can be permanently dulled by ag...
Tile itself is easy to clean. Grout is porous, sits below the tile surface where mopping cannot reach it, and absorbs soil, grease, soap residue and moisture until it darkens several shades. Mop water pushed across a floor deposits that soil directly into the...
Draperies collect airborne soil, cooking residue, smoke, dust and odor continuously, and because the change is gradual most people do not notice until the fabric is cleaned. They are also among the easiest household textiles to ruin. Lined draperies, silk, ray...
Duct systems circulate the entire volume of air in a building many times a day. When a fire, sewage backup, mold problem, renovation or infestation contaminates a property, the HVAC system distributes that contamination into rooms the original event never touc...
Upholstered furniture holds body oils, perspiration, dander, dust, cooking residue and smoke deep in its fibers and padding, and unlike flooring it sits at breathing height and in direct skin contact. It is also expensive to replace, and quality frames commonl...
The measure of a professional restoration project is what the rest of the building looks like when it is finished. Demolition, remediation and drying generate dust, spores, particulate and odor that will migrate into unaffected rooms through open air paths, th...
Plastic sheeting taped to a doorway is not containment. Real dust-proof containment is an engineered barrier system with a sealed perimeter, a rigid or tensioned frame, a controlled entry and a managed pressure relationship. It is what keeps demolition dust, s...
A significant share of the damage on restoration and renovation projects is caused by the project itself: equipment traffic, dropped tools, dragged materials, dollies, foot traffic and construction debris ground into finished floors. Hardwood, natural stone, t...
Negative air pressure is the engineering control that makes contaminated work safe to perform inside an occupied building. By exhausting more air from the containment than enters it, the enclosure is held at lower pressure than the surrounding space, so air al...
Custom cabinetry, wainscoting, raised paneling, built-in millwork, layered floor and wall assemblies and coffered ceilings are the elements of a property that are expensive, slow and sometimes impossible to reproduce. They are also the hardest things in a buil...
